Jean,
Do you have a relatively simple project that exhibits the problem?
It would be helpful in debugging the Type.
Best,
David
On 11/6/2012 07:45, Jean Marais wrote:
When no air (or very little) passes through the coil (type 52b),
the outlet air temp becomes that of the coil water. I have a
problem that the type is internally calling a routine for the wet-
bulb calculation which is outside of range (Temp more than 70
degC). This error is TERMINATING my simulation although I only get
it once. I also get a saturation warning everytime condensation
occurs on the coil when I use it as a cooling coil. I have been
advised to recompile this type with some adjustments, but I have no
resources to do so. Please advise.
Jean Marais
TRNSYS Message 114 : The utility routine PSYCHROMETRICS, which
calculates the thermodynamic properties of moist air, has been
called with a wet bulb temperature above the maximum wet bulb
temperature for the given pressure. Please check the routine which
calls the PSYCHROMETRICS routine for possible sources of errors.
Reported information : Error 114
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com