Welcome to the TRNSYS Users Forum.

The forum is a place where people can interact and have discussions about different topics involving the use of the TRNSYS software package. Here you can post topics for discussion or questions on using TRNSYS and get advice from other users or TRNSYS experts. This forum is not intended for detailed technical support. Users should contact their distributor’s hotline for such assistance.

Some tips for success on using the forum:

  • Follow the Forum Rules posted in Forum Administration.
  • There are categories for different types of topics and questions. Post your topic or question into the proper category.
  • Before posting a topic or question search the existing topics  (and the TRNSYS Users listserv archive or Post archive) to see if a similar topic or question has already been answered.
  • Use a descriptive topic name. Don’t use attention getting subjects, they don’t get attention and only annoy people.
  • State the version of TRNSYS and which add-ons your are using.
  • Include enough specific details for your topic of question to be answered. Just posting “Why am I getting an error?” without describing the specific error and what you are trying to do when you get the error will not receive a response that fixes your issue.
  • Remember when people help you, they are doing you a favor. Be patient, help people out by posting good descriptions of what you need help with, and be polite even if a response does not solve your issue.
  • Moderators may edit your post for clarity or move your topic to a more appropriate category.

Notifications
Clear all

Active layer setting and outputs

3 Posts
2 Users
0 Reactions
1,072 Views
0
Topic starter

Hi everyone,

    i want to simulate a ground floor with active layer, hot water from a tank,  but i can't set the output of TOFL (fluid outlet temperature of active layer), just see the warning " Ntype=58 please select one wall with active layer!"

    so what's wrong with the setting?

chushunzhou Topic starter 03/04/2025 6:45 am

the warning message

chushunzhou Topic starter 03/04/2025 6:46 am

the seeting about floor heating

1 Answer
0

@chushunzhou

I think you may just have to click on the name of the NTYPE that you have selected in the list in the lower left hand side of the window and then select the surface(s) for which you want to see that output.

Share: