[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Type 56

Dear users, I am modeling a system with a radiant ceiling panel with Trnsys 17.I have inserted an active ceiling layer in the Type56 .. when I try to enter the flow rate parameters for each thermal zone, I cannot change the allowed inlet mass  flow (in which “-1 # J” is inserted by default. in addition to this problem there is no box to perform self-segmentation. Has anyone had and solved the same problem? hoping for your help, thank you.
 Regards
Simona
Inviato da iPhone