|
Hoofar,
Unfortunately I think the problem may have to do with EES being
located in the C:\Program Files (x86)\ directory. I am a bit
surprised that spaces in the pathname are giving you trouble, you
should be able to type the path enclosed in double quotes
and have it resolve correctly. I will certainly have a look and
make sure that we don't have a problem there. Can you send me the
TRNSYS project and EES file that you are working with? I can see
if it is possible to recreate the problem here.
However, spaces in path names aside, Windows is very restrictive
about allowing software to create or modify files in the \Program
Files\ directory. Even if the user account has administrative
rights, the software itself may not and Windows will block the
communication. I realize in your email you said that you cannot
move EES out of the \Program Files (x86)\ so I realize this
response may be of limited use.
regards,
David
On 04/02/2019 15:03, Hemmatabady,
Hoofar wrote:
Hi David,
No, I could not find a solution yet.
Best regards,
Hoofar
Hoofar,
Did you find a solution to this problem? I am just back
from a week out of town and I don't see a response.
regards,
David
On 03/22/2019 04:48, Hemmatabady,
Hoofar via TRNSYS-users wrote:
Dear TRNSYS users,
I am coupling TRNSYS with EES. EES is
installed in (C:\Program Files (x86) \EES32). After I
changed the location of EES in type 66a, got the following
error:
"TRNSYS
Message 48 : The TRNSYS processor has reported that an
>
unrecognized control card was found while trying to
read the input
> file. This error can be caused by
underspecifying a required number of
> items in the input file. For example, specifying
only 9 parameters > after a "PARAMETERS 10"
card has been read can cause this error. The
> line that caused this error is listed in the
reported information > below.
Reported information: compressor.ees
When I run the same example in another
computer, which has EES installed in (C:\EES32), it works.
I found that labels with spaces are not allowed in TRNSYS
((Program Files (x86) is read by TRNSYS as
Program files because of the space between Program
files and (x86)!!). As I cannot change the location
of EES in my main server, I tried to solve the problem by
adding double-quote “C:\Program Files (x86) \EES32”or
single-quote ‘C:\Program Files (x86) \EES32’ but I got the
following error again:
The EES
program was not found at the specified location.
How can I solve this problem?
Best regards,
Hoofar
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com
|