[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] TRNSYS-EES coupling error



Hoofar,

  Did you find a solution to this problem? I am just back from a week out of town and I don't see a response.

regards,

 David


On 03/22/2019 04:48, Hemmatabady, Hoofar via TRNSYS-users wrote:

Dear TRNSYS users,

 

I am coupling TRNSYS with EES. EES is installed in (C:\Program Files (x86) \EES32). After I changed the location of EES in type 66a, got the following error:

 

"TRNSYS Message 48 : The TRNSYS processor has reported that an > unrecognized control card was found while trying to read the input > file. This error can be caused by underspecifying a required number of > items in the input file. For example, specifying only 9 parameters > after a "PARAMETERS 10" card has been read can cause this error. The > line that caused this error is listed in the reported information > below. Reported information: compressor.ees

 

When I run the same example in another computer, which has EES installed in (C:\EES32), it works. I found that labels with spaces are not allowed in TRNSYS ((Program Files (x86) is read by TRNSYS as Program files because of the space between Program files and (x86)!!). As I cannot change the location of EES in my main server, I tried to solve the problem by adding double-quote “C:\Program Files (x86) \EES32”or single-quote ‘C:\Program Files (x86) \EES32’ but I got the following error again:

 

The EES program was not found at the specified location.  

 

How can I solve this problem?

 

Best regards,

Hoofar

 

 


_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com