[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] TRNSYS-EES coupling error



Dear TRNSYS users,

 

I am coupling TRNSYS with EES. EES is installed in (C:\Program Files (x86) \EES32). After I changed the location of EES in type 66a, got the following error:

 

"TRNSYS Message 48 : The TRNSYS processor has reported that an > unrecognized control card was found while trying to read the input > file. This error can be caused by underspecifying a required number of > items in the input file. For example, specifying only 9 parameters > after a "PARAMETERS 10" card has been read can cause this error. The > line that caused this error is listed in the reported information > below. Reported information: compressor.ees

 

When I run the same example in another computer, which has EES installed in (C:\EES32), it works. I found that labels with spaces are not allowed in TRNSYS ((Program Files (x86) is read by TRNSYS as Program files because of the space between Program files and (x86)!!). As I cannot change the location of EES in my main server, I tried to solve the problem by adding double-quote “C:\Program Files (x86) \EES32”or single-quote ‘C:\Program Files (x86) \EES32’ but I got the following error again:

 

The EES program was not found at the specified location.  

 

How can I solve this problem?

 

Best regards,

Hoofar