[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Error in simulation

What was the error listed in the LIST file?  99% of the time that will show you exactly where the problem is.  You should check this file after every simulation to look for warnings, non-convergence etc.

Jeff Thornton
TESS

Sent from my iPhone

On Jul 12, 2017, at 4:27 AM, Ismail OUHALLOU via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:

Dear Tnsys users,

I want to simulate an AHU building integrated using type 112b. Control signal of type 112b is: The fan (type 112b) is to be ON if the relative humidity of a zone is greater than 70%.
When I run simulation, it gets blocked at a given time as shawn in figure below:
<Capture.PNG>
​
Where does the problem come from ?

Thanks in advance
Ismail


--
************************************************
Ismail OUHALLOU
Green building & Sustainability consultant

Morocco
P:+212 620 548 116
F:+212 522 326 440



<Capture.PNG>
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org