[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] TRNSYS message 129



Dear all,

I try to simulate an heating component modeled with ees software, in TRNSYS environment  by using type 66a (calling  ees routines).

The simulation works for few time steps but finally crash with the following error message:

 

“TRNSYS Message    129 : The referenced Unit has tried to set an Output value higher than the number of Outputs that the Type reserved for itself.”

 

Could someone explain me what it means?

 

Best regards

Matthieu