Dear TRNSYS users, Thanks for your time. I am currently performing a simple validation of an air source heat pump system. The air-source heat pump is Type941, and I am using a defined thermal load (Type682) with an input file (Type9). However, the results I am getting for the Total Heat Transfer to Liquid from output option in air source heat pump component is between 2 and 3 times higher than the Heating Load Met from output option in thermal load. I cannot think of any reason why the generated energy is significantly higher than the load met. I would understand if the generated energy is a bit higher than the load met as there might be heat losses from connected pipes. Could anyone give me some advices? This is very important for me to continue my research project. Thanks very much in advance. Zhe Li Tá an teachtaireacht seo scanta ó thaobh ábhar agus víreas ag Seirbhís Scanta Ríomhphost de chuid Seirbhísí Faisnéise, ITBÁC agus meastar í a bheith slán. http://www.dit.ie This message has been scanned for content and viruses by the DIT Information Services E-Mail Scanning Service, and is believed to be clean. http://www.dit.ie |