Re: [TRNSYS-users] TYPE534 Parameters, Error

[Matteo DF <deframat@gmail.com>]

Hi,
I've had similar problems when i replaced type 60 with type 534 from
Tess; you can search previous messages... anyway if you have problems
with parameter number around 40 you should look into your heat
exchanger dimensioning maybe it is too large or you have some problems
with the placement.
Unfortunately up to now there's no correlation between parameter
errors and corrisponding parameter in the type configuration...

Regards,
Matteo.

On 25 February 2010 01:55, Edward Halawa <Edward.Halawa@unisa.edu.au> wrote:
> Dear All,
>
>
>
> I managed to replace TYPE 60 with TYPE 534. However, when I run the project,
> the error (see the attachment) appears. As you can see, the  error message
> refers to PAR(45). But TYPE 534 only has 5 parameters listed in the
> proforma. (Note: TYPE534 uses plugin and shows another window which displays
> all the parameters such as tank properties, loss etc.)
>
>
>
> TYPE534 documentation doesn’t help much on this.
>
>
>
> I appreciate your help.
>
>
>
> regards,
>
> edward
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@cae.wisc.edu
> https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
>
>



-- 
La scoperta è vedere ciò che tutti hanno sempre visto e
pensare ciò che nessuno ha mai pensato.
(Albert Szent-Gyorgyi, scopritore della vitamina C e premio Nobel)