Re: [TRNSYS-users] Help Needed with TRNSYS modeling

["Jeff Thornton" <thornton@tess-inc.com>]

<Upon running the simulation, i encounter an error msg:
TRNSYS Message 103: The TRNSYS type checking routine has found an
inconsistency in the specified component between the input file and the
information expected by the Type.
Reported information: An illegal PARAMETER value has been reported by the
model. The model has reported that Parameter 31 is the problem - but this
may not be the case. Please check the component configuration.>

If I were to take a guess, I would guess that you probably set the 5
visible parameters for the Type 531 storage tank that are located in the
parameters tab but did not use the plug-in tool (magic wand icon on the
parameters tab) to completely set up the storage tank.  If you did use the
plug-in, then carefully go through each cycle of variables to make sure
you're not setting a node indicator beyond the maximum number of nodes
that you have specified.

jeff



Jeff Thornton
President - TESS, LLC

2916 Marketplace Drive - Suite 104
Madison WI 53719 USA

Phone: 608-274-2577
Fax: 608-278-1475
E-mail: thornton@tess-inc.com
Web: www.tess-inc.com