Welcome to the TRNSYS Users Forum.

The forum is a place where people can interact and have discussions about different topics involving the use of the TRNSYS software package. Here you can post topics for discussion or questions on using TRNSYS and get advice from other users or TRNSYS experts. This forum is not intended for detailed technical support. Users should contact their distributor’s hotline for such assistance.

Some tips for success on using the forum:

  • Follow the Forum Rules posted in Forum Administration.
  • There are categories for different types of topics and questions. Post your topic or question into the proper category.
  • Before posting a topic or question search the existing topics  (and the TRNSYS Users listserv archive) to see if a similar topic or question has already been answered.
  • Use a descriptive topic name. Don’t use attention getting subjects, they don’t get attention and only annoy people.
  • State the version of TRNSYS and which add-ons your are using.
  • Include enough specific details for your topic of question to be answered. Just posting “Why am I getting an error?” without describing the specific error and what you are trying to do when you get the error will not receive a response that fixes your issue.
  • Remember when people help you, they are doing you a favor. Be patient, help people out by posting good descriptions of what you need help with, and be polite even if a response does not solve your issue.
  • Moderators may edit your post for clarity or move your topic to a more appropriate category.

Notifications
Clear all

[Solved] Error CTypeLib::GetPosInputType, when reimporting IDF-Files to TRNBuild

1 Posts
1 Users
0 Likes
76 Views
0
Topic starter

Hello TRNSYS-users,

I export a 3D data model to a TRNSYS3d file (idf file) in TRNBuild. Then I make some changes to the 3D geometry in Sketchup, using the trnsys3d plug-in. Then I save the new idf-file under a different name.

After returning to TRNBuild and importing the file again, I get the warning while saving: CTypeLib::GetPosInputType Inputtype <userdefinded> not found.

Even if I do not make any changes to the 3D geometry and re-import the idf-file, I get the same message. The problem is that TRNSYS crashes when I load this B18-file in the simulation studio.

I am working with TRNBuild 3.0 (TrnsysRelease = 18.02.0002) and Trnsys3d Version 1.0.7.2.

 

Best regards,

Leopold Modrakowski

1 Answer
0
Topic starter

the problem was solved when I changed the FSOLAIR from INPUT to a constant value in the IDF file source code before re-importing it into TRNBuild

Share: