Archit,
This kind of question is usually better addressed directly to
the technical support hotline for your Trnsys distributor. They
will need you to send them the project and any other files needed
in order to run it. If you aren't sure who to contact, please send
me a direct message and I will put you in touch with the
appropriate hotline.
kind regards,
David
On 4/17/2023 6:58 AM, ARCHIT MAHAWAR
19BME0489 via TRNSYS-users wrote:
Sir we are struggling with the internal
connections of our hot water system. We did the same connections
in the evacuated tube collector as we did with flate plate
collector. Our flat plate system simulation is working fine but
we are facing errors while doing same connections with evacuated
tube one. I am attaching the images of the systems and the
errors faced. The 1st image is the system with flate plate
collector and 2nd with evacuated tube collector.
Disclaimer:
This message was sent from Vellore Institute of Technology.
The contents of this email may contain legally protected
confidential or privileged information of “Vellore Institute
of Technology”. If you are not the intended recipient, you
should not disseminate, distribute or copy this e-mail. Please
notify the sender immediately and destroy all copies of this
message and any attachments. If you have received this email
in error, please promptly notify the sender by reply email and
delete the original email and any backup copies without
reading them.
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
--
***************************
David BRADLEY
Principal
Thermal Energy System Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com