Tarek,
For some reason none of the zones that you drew in SketchUp/Trnsys3d were written to the *.idf file. If you did not already do so, please try and step through the relevant section of the 09-Tutorials manual as it explains the process. If you have done that and are still having problems I would recommend contacting your distributor for assistance.
kind regards,
David
On 09/13/2022 09:44, Tarek El Shafey via TRNSYS-users wrote:
I built a building using sketchup 2019 and tried to import it to Studio simulation, but an error occurred. It says " At least 2 surfaces are required per zone ". I am attaching the modelling file in idf extension. Please tell me where the problem is.
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org-- *************************** David BRADLEY Principal Thermal Energy System Specialists, LLC 3 North Pinckney Street - suite 202 Madison, WI 53703 USA P:+1.608.274.2577 d.bradley@tess-inc.com http://www.tess-inc.com http://www.trnsys.com