Re: [TRNSYS-users] Problem with importing multizone building from sketchup 2019 to Trnsys 18.

[David BRADLEY <d.bradley@tess-inc.com>]

Tarek,

 For some reason none of the zones that you drew in SketchUp/Trnsys3d were written to the *.idf file. If you did not already do so, please try and step through the relevant section of the 09-Tutorials manual as it explains the process. If you have done that and are still having problems I would recommend contacting your distributor for assistance.

kind regards,

 David

On 09/13/2022 09:44, Tarek El Shafey via TRNSYS-users wrote:

I built a building using sketchup 2019 and tried to import it to Studio simulation, but an error occurred. It says " At least 2 surfaces are required per zone ". I am attaching the modelling file in idf extension. Please tell me where the problem is.

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy System Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com