Dear Users,
I am facing a problem with a TRNSYS simulation (basically a BUI file with the building's features and a .tpf file where I implemented other components, e.g., CO2 balance, ventilation system and so on). I realised that when I run the simulation directly by opening the .tpf file, the simulation works. However, when I open simulation studio and import the TRNSYS Input file, and run the simulation, an error occurs in an Equation tool.
I tried the same with many folders, but the same happens with every simulation.
I cannot figure it out why and, if maybe this is "normal"...
Best Regards,
--
Maja Danovska
Research Fellow
Dep. of Civil, Environmental and Mechanical Engineering
University of Trento
via Mesiano, 77 - 38123 - Trento - ITALY
+393403391289