Re: [TRNSYS-users] Type 539 and 538

[Ali Shahrouzian <ALISHAHROUZIAN@cmail.carleton.ca>]

Hi Jeff,

Thank you for your response.

I double checked my parameters and inputs, and then I added a control in such a way to turn off the heat exchanger and the pump when the collector mass flow rate is zero.
It worked properly. However, when I changed the weather file (choosing a weather file related to the colder regions), it seems that the results are not logical.
Could you please run another simulation with a weather file related to the colder climate?
And one more thing, in your email, you talked about adding pipes. Could you please guide me where I can add these pipes in the solar loop in this case? And what is the reason behind that?

Thanks in advance
Ali


-----Original Message-----
From: thornton@tess-inc.com <thornton@tess-inc.com> 
Sent: August 25, 2021 1:20 PM
To: TRNSYS users mailing list at OneBuilding.org <trnsys-users@lists.onebuilding.org>
Cc: Ali Shahrouzian <ALISHAHROUZIAN@cmail.carleton.ca>
Subject: Re: [TRNSYS-users] Type 539 and 538

[External Email]

On 2021-08-24 22:13, Ali Shahrouzian via TRNSYS-users wrote:
> However, when I directly connect the heat exchanger outlet to the 
> collector inlet, the mass flow rate of the solar loop increases 
> rapidly and reaches its maximum value.

Ali,

I just did exactly as you described and it worked just fine here.  See attached image.  Please check your parameters and inputs carefully.
Make sure you have a small timestep, and also consider adding pipes and the pump.  Make sure you have enough flow on the other side of the heat exchanger to remove the heat from the collector.  If you still cannot discover why it isn't working then I suggest you send your project to your distributor to see what they can find.

Jeff
--
Jeff W. Thornton
President
Thermal Energy System Specialists LLC
3 N. Pinckney Street, Suite 202
Madison WI 53703 USA
(608) 274-2577
www.tess-inc.com