I would recommend that you get in touch with your TRNSYS distributor. You'll need to send them the project and all the files needed in order to run the simulation.
kind regards,
David
Hello everyone,I'm simulating a building using Type 56 of TRNSYS 18, when I plotted the interior relative humidity of a zone, I found illogical values, the humidity is above 100%. However, using the sameTPF in TRNSYS 17, the humidity values are good!
There any problems in TRNSYS 18 about interior humidity?Thank you for your helpBest,Hassan------------------------Hassan MAHACH, PhD studentEnergy Processes Research Group, LMFE, Faculty of Sciences Semlalia.EnR2E Laboratory, National Center for Studies and Research on Water and Energy (CNEREE)Cadi Ayyad University Marrakech, MoroccoTel: +212 618 20 37 74
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-- *************************** David BRADLEY Principal Thermal Energy Systems Specialists, LLC 3 North Pinckney Street - suite 202 Madison, WI 53703 USA P:+1.608.274.2577 F:+1.608.278.1475 d.bradley@tess-inc.com http://www.tess-inc.com http://www.trnsys.com