Hello everyone,
I'm simulating a building using Type 56 of TRNSYS 18, when I plotted the interior relative humidity of a zone, I found illogical values, the humidity is above 100%. However, using the sameTPF in TRNSYS 17, the humidity values are good!
There any problems in TRNSYS 18 about interior humidity?
Best,
Hassan
------------------------
Hassan MAHACH, PhD student
Energy Processes Research Group, LMFE, Faculty of Sciences Semlalia.
EnR2E Laboratory, National Center for Studies and Research on Water and Energy (CNEREE)
Cadi Ayyad University Marrakech, Morocco
Tel: +212 618 20 37 74