Re: [TRNSYS-users] how to find the source of the error ?

[David BRADLEY <d.bradley@tess-inc.com>]

Fu,

 Most errors will be associated with a Unit and Type number, both of which will be shown in the error log. When you return to the Assembly Panel in the Studio and press the F2 key, the names of the components will toggle to show each component's Unit and Type number. There are some error messages that are not associated with a Unit and Type number, in which case "0" is displayed. In the case of the error you received, the input file is being checked to make sure that all the referenced external files files exist. Unfortunately, this check is done globally, not on a component by component basis so while the message is associated with a particular Unit and Type, the routine that is checking does not actually know (yet) what Unit and Type is associated with each file.

kind regards,

 David

 

On 10/29/2019 12:28, Fu Yiwei via TRNSYS-users wrote:

I am using TRNSYS 18, if I set the external file of the component “Weather” as empty, TRNSYS would give me an error message.

But I am wondering what is the meaning of this message, I can’t see the connections.

How should I locate the source of the error based on the messages?

 

发送自 Windows 10 版邮件应用

 

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com