Re: [TRNSYS-users] TRNSYS crashes with no error message, but a lot of warnings refering to the PSYCHROMETRICS routine

[C K Lee <a8304506@graduate.hku.hk>]

Dear Knut.

My experience is that the most possible causes of so many warnings are 
due to inappropriate fluid mass flowrates and/or insufficient thermal 
capacitances in the fluid streams.  You may trace the problems in these 
directions.

Best Regards
C K Lee
Research Fellow
City University of Hong Kong


On 2019-05-02 21:59, David BRADLEY via TRNSYS-users wrote:
> Knut,
>
>   In migrating to 64-bit architecture we have run into some situations
> where the 32-bit version managed to get through an iteration while the
> 64-bit version doesn't. Can you please send me the project and all the
> files needed in order to run it so that I can have a look where it is
> getting hung up?
>
> thank you,
>
>  David
>
> On 05/02/2019 04:38, Knut Erik Enerstvedt via TRNSYS-users wrote:
>
> > Hello,
> >
> > When running a simulation, TRNEXE crashes after a while without
> > displaying any error message. Usually it pops up a box saying there
> > is an error, but now it just freezes with a "Program not responding"
> > message in the top of the window. When I close the program, the log
> > file window appears. It shows no errors, but a lot of warnings
> > saying that "The referenced UNIT has called the PSYCHROMETRICS
> > routine with conditions outside the intended range of the dew point
> > temperature correlation. The correlation from the 1981 ASHRAE
> > fundamentals handbook is for the temperature range of -60 C to 70
> > C." These warnings refer to units of Type 670 and 995 (TESS heating
> > and cooling coil). I have tried to increase the setting "number of
> > warnings before error" as a work around, since I can't understand
> > why these warnings appear. I also do not know if these warnings are
> > the reason why TRNEXE crashes, since there is no error message
> > saying that they are, but I have no other clues.
> >
> > I would appreciate if anyone has an idea why this happens. My TRNSYS
> > version is 18.01.0000.
> >
> > Best regards
> >
> > Knut Erik Enerstvedt
> >
> > Gether AS
> >
> > _______________________________________________
> > TRNSYS-users mailing list
> > TRNSYS-users@lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
> > [1]
>
> --
> ***************************
> David BRADLEY
> Principal
> Thermal Energy Systems Specialists, LLC
> 3 North Pinckney Street - suite 202
> Madison, WI 53703 USA
>
> P:+1.608.274.2577
> F:+1.608.278.1475
> d.bradley@tess-inc.com
>
> http://www.tess-inc.com [2]
> http://www.trnsys.com [3]
>
>
> Links:
> ------
> [1] 
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
> [2] http://www.tess-inc.com
> [3] http://www.trnsys.com
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org