There may be an equation or the label of a variable being
printed or plotted that starts with the letters PK. If you are not
able to find it then I would recommend you contact your
distributor and send them the project (*.tpf) as well as any files
needed to run the simulation. If you aren't sure who to contact,
please send me a direct email and I can point you in the
appropriate direction.
Dear researchers,
I have met a problem with TRNSYS simulation showing
that "Unrecognized variable name or bad data card. TRNSYS
was looking for a numerical value or the name of a variable
defined in an equation/constant and instead it found the
data of PK...".
Actually, I did not find any information on PK... in
my model. Could you please help.
The detailed error information is shown in the figure below:
Hope you can help me.
Best Regards,
Jasmine.
Disclaimer:
This message (including any
attachments) contains confidential information intended
for a specific individual and purpose. If you are not the
intended recipient, you should delete this message and
notify the sender and The Hong Kong Polytechnic University
(the University) immediately. Any disclosure, copying, or
distribution of this message, or the taking of any action
based on it, is strictly prohibited and may be unlawful.
The University specifically denies any
responsibility for the accuracy or quality of information
obtained through University E-mail Facilities. Any views
and opinions expressed are only those of the author(s) and
do not necessarily represent those of the University and
the University accepts no liability whatsoever for any
losses or damages incurred or caused to any party as a
result of the use of such information.
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org