_______________________________________________Mohamed,
Open the proforma for the model in question. Change the minimum from 1 to 0 and save the proforma. Then use the REFRESH menu option to load your changes into the Studio. When you drag out a new version your change should be apparent. While we are talking about Type 60 please be somewhat careful. Other users have reported strange behavior with that model and we have removed it from the standard library in newer releases.
Jeff
---
Jeff Thornton President - TESS LLC 3 N. Pinckney Street, Suite 202, Madison WI USA 53703 Office: (608) 274-2577 Fax: (608) 278-1475 www.tess-inc.com E-Mail: thornton@tess-inc.comOn 03/18/2019 3:06 pm, mohamed sarmouk via TRNSYS-users wrote:
Hello everyone,i am working with the type 60j (horizontal cylinder), in order to enter the height of the tank for a horizontal cylinder i should enter its diameter and in my case its 450 mm or 0.45 m.the problem is when i run the calculation an error occur (Message : One or more of the parameters entered as heights exceeds the height of the tank.) i checked and i found that height of heating element 2 & height of thermostat 2 are set by default to 1m and the range is between [1;15]m so it can't be set to a value below 1m.would you please give me an alternative or a solution if there is one.kind regards.M.SARMOUK
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org