Olivier,
I don't think that Type56 has outputs for the outlet mass flow
rate from an active layer. It does, of course, have outputs for
the outlet temperature. However, since the inlet and outlet mass
flow to/from the active layer are equal you can just pass the mass
flow rate directly from collector to tank (bypassing the house)
while the temperature into the tank will come from the house.
kind regards,
David
On 02/25/2019 12:09, Le Talave via
TRNSYS-users wrote:
Dear Trnsys community,
I try to simulate a house heated by sensors and solar
collectors. I did a type 56 of the house and 5 active layers
simulating heated walls. The house and collectors are each
connected to a pump and a solar tank with 2 HX, everything works
well.
I want to put the collectors and the house in series (coll->
house-> tank-> coll). Now, an error occurs because there
is no flow information between the house and the tank. When I
created active layers, I linked their temperature / flow to 2
inputs connected to a pump in Trnsys. But is it possible to
create 2 temp/flow outputs to be able to connect the house to
the tank?
Thank you very much for your advice
Best regards,
Olivier
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com