[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Type 1244 - Incoherence in boundary temperatures



Dear all,

I am modeling a residential building with the above ground floor modeled as a single zone, and a single zone basement, and I intended to use Type 1244 to confirm whether or not my first assumption to use Type 77 instead was valid.

However, using type 1244, after about 2600 hours into the simulation, the boundary temperature of the soil spikes rapidly, eventually reaching unrealistic values (in the thousands of °C!). 

I have mapped the single zone basement based on the TESS tutorial, and I have left most of the parameters for the soil unchanged, except for the Deep earth temperature (10 °C) and Amplitude of surface temperature (20 °C). The set point in cooling for the zone is 26 °C.

I am running a 0.5h time step, and 0.1 °C convergence temperature, tough this last parameter did not seem to have a lot of effect on the results.

If anyone ever encountered this issue and could direct me to a possible solution, it would be greatly appreciated!

Thanks!

Olivier Quevillon

Étudiant à la maîtrise en Génie Mécanique
École de Technologie Supérieure