[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Climate data

Hello every one

I am new user of TRNSYS. I am looking forward to simulate in Type 56 3D, but I just found that it is necessary to have TM2 climate data file? But for Cuenca, Ecuador I just found only .EPW file. It is possible to simulate in type 56 with EPW ? or it is possible to export EPW file to TM2? or using the adequate climate Type 15-4 ? Thank you in advance for your help


Kind regards

Esteban Zalamea León
Arquitecto
PhD Arquitectura y Urbanismo UBB
Coordinador Maestría en Construcciones
Universidad de Cuenca
Tlf 593 98 331 1604 /  07 405 1102 Ext. 2153


El 06-11-2016, a las 10:09, Jeff Thornton via TRNSYS-users <trnsys-users@lists.onebuilding.org> escribió:

Ismail,

Your approach of connecting the soil temperature to the boundary temperature will work but will likely over-estimate the loads - sometimes significantly.  The storage in the ground around the basement can play an important role.  There are several good ground modeling components out there but I would recommend Type1267 from TESS after looking at your schematic.  The model will likely slow down the simulation but will provide MUCH more realistic results.  And with the included soil temperature viewer you'll be able to visualize the heat transfer into the soil.  We use it on all of our basement projects.  There are several tricks we can share to help with the simulation speed issue too.

Jeff Thornton

Sent from my iPhone

On Nov 4, 2016, at 12:55 PM, Issmail OUHALLOU via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:

​Dear Trnsys-experts,

Would anyone happen to have an experience on advanced building modeling with basements included? I am trying to model a building in TRNSYS 17 using type 56. My building includes three basements as shown in figure below.

<317.4.1f-Fluchtwege-UG7.6.gif>
​I am wondering if what I have done puts me in the right path, to know: I used Type 77 to model a simple ground temperature, then the output (soil temperature at Node) has been connected to TBOUNDARY. In fact, I have set three Nodes in type 77 (one node for each basement) and the walls's boundary conditions of the basements are = 1*TBOUNDARY.

Thanks in advance

Regards,
Ismail
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org