Re: [TRNSYS-users] Number format when using parametric table in TRNEdit

[Nordine Belaissaoui via TRNSYS-users <trnsys-users@lists.onebuilding.org>]

Hi,

In your example you're talking of 201 and 210. Those are 2 different logical units. 

Can you first make sure of your example in your email. It may just be a misunderstanding in your email. 

Then, I think your issue is caused by an other logical unit in the same file. 

You must make sure that there is no other 201 (210) logical unit used in that .dck. 

I personally started my own logical unit from 39000 and it works fine. 

On Monday, 30 May 2016, Christian Herløv Krintel <trnsys-users@lists.onebuilding.org> wrote:

Dear all,
I have a parametric table with a list of logical units, which I use to choose different weather files for my simulation.
Some of the runs are omitted due to errors. It seems that these errors are caused by the number formatting.

For instance when opening the first .dck file, e.g. TEST1.dck, it says something like

ASSIGN "Weather\file.tm2" 2.0100E+02

Even though I just put "210" in the parametric table. The error disappears when I change the number into "210" and run the .dck file again.
How can I circumvent this propblem?

Thank you
Best regards
Christian Krintel
Technical University of Denmark
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
Nordine Belaissaoui 
--
DualSun - Product Manager, M.Sc Energy Engineering
Phone : +33 4 13 41 53 71
Email : nordine.belaissaoui@dualsun.fr
Address : Pôle de l'Etoile - 38 rue Frédéric Joliot Curie - F 13451 Marseille Cedex 13
www.dualsun.fr | Page Facebook | Fil Twitter  | Profil LinkedIn  | Page Google+