It is unlikely that you have installed the GenOpt program in the C:\Trnsys17\Optimization directory. You need to set this directory to the one that you had GenOpt install its files into.
The main TRNSYS directory is the where the TRNSYS files are located and not where your project file is saved. I would guess that yours should be set to C:\Trnsys17.
All of these are covered in the TrnOpt manual. I suggest that you work through the example project first before starting your own optimization.
Regards,
Tim
---
Timothy P. McDowell Executive Vice President Thermal Energy System Specialists, LLC 22 N Carroll St, Suite 370 Madison, WI 53703 608-274-2577
On 2016-04-14 22:15, pshtony@gmail.com wrote:
Hello Users,I'm using TRNSYS 17 and recently, I try to use genopt(TRNOPT) in the optimization library. But I don’t know what is wrong since the last week.Using the TRNOPT component, I was set some parameters to optimize my template. And then, at the 'setting' tab, in the TRNOPT17(TRNSYS - GenOpt link program), I also designate the three kind of file location1. directory where the GenOpt Folder is located : C:\Trnsys17\Optimization\2. Location of Java Files : C:\Program Files (x86)\Java\jre1.8.0_77\bin\3. Main TRNSYS directory : C:\Users\SEUNGHOON\Desktop\RnD\DST_Model\DSTvolume\Practice\TRNSYSprojets\projectHR\37FLSBCIgfunction\(my simulation studio file is here in this 37FLSBCIgfunction folder)And I did all I need (select input file as ~.dck, variables, and specify variables and select optimization method also)But If I click the 'Run Optimization' , I can see this error message. "GenOpt could not be found. Please check the directory in settings".Did I do something wrong?? Please give an advice.Best regard,
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org