Re: [TRNSYS-users] Editing the parameters of Type1288

[David BRADLEY <d.bradley@tess-inc.com>]

Katerina,
 There is probably a maximum allowable number of transverse angles set in the proforma for that component. You can open the proforma (not the implementation of the proforma in the project but the proforma itself) and increase the allowable maximum value of that parameter. Once you do, save the proforma then right click on the 1288 proforma in your project and select "replace" from the context menu. Browse to find the modified Type1288 proforma.
kind regards,
 David
 

On 03/04/2016 01:49, Katerina Isaakidou wrote:

Dear users, 

I would like to edit the parameters of the Type1288 Concetrator. I have all the needed data to do so, but when I try to change the number of the Transverse Angles in the Parameters Window it goes back to the default 8. All other parameters' values I can type in and edit, except that one. Does anybody know why that? Is there anything else I could do to fix this problem?

Thanks a lot in advance,

Katerina

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com