Re: [TRNSYS-users] type 533 error

[David BRADLEY <d.bradley@tess-inc.com>]

Alex,
 It would be best to send this question to your distributor's technical support hotline; they can help you figure out which parameter is giving a problem. In the mode in which you are running Type533 it reads its parameters from an external file. Unfortunately the file isn't commented because it is intended for data transfer between the plugin and the Type so it is hard to tell which parameter is causing the problem.
kind regards,
 David

On 06/13/2015 07:35, ALEXANDROS PECHTELIDIS wrote:

Hi everyone,

I tried to add a thermal storage (type 533), to the existing Tess Models example high temperature solar library/annual solar field.tpf, before the expansion tank, connecting the solar field to it's HX1 .

Everything was just fine and the model ran with no errors. 

Then I would like to add component for the second heat exchanger of type 533 (HX2). I chose type 114 trying to simulate a geothermal well (flowrate=15 m3/hr and temperature 60C).

This end up in 2 fatal errors in the log file. see the attached jpeg.

I cannot find parameter 50 for type 533 in it's parameter tab.

Do you have any suggestions?

Kind regards 

Alex

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com