[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] question about coupling TRNSYS/CONTAM using the type 98



Hello all.

 

I try to run the example ``cottage-dcv_T3D_imported_coupled_imported.tpf’’ which uses the type 98 for running coupled CONTAM/TRNSYS simulations, but I get the following error:

 

*** Fatal Error at time   :         0.000000

    Generated by Unit     : Not applicable or not available

    Generated by Type     :    98

    TRNSYS Message    105 : A TYPE was called in the TRNSYS input file but was either not linked into trndll.dll or was not found in an external dll. A dummy subroutine was called in its place. Please link the TYPE or remove it from the input file

    Reported information  :  Type98 could not be located in either the trndll.dll or in an external dll. Please relink theTRNDll.dll including this Type or make sure that an external DLL in the \UserLib\DebugDLLs and \UserLib\ReleaseDLLs folders contain the Type.

 

It seems TRNSYS does not find the *.dll file, however there is a Type98Lib.dll file at \UserLib\ReleaseDLLs folder.

 

Am I missing something?... I followed all the instructions given at the contam user guide manual and in the example of TYPE98.

 

Best regards.

 

Juan Francisco Belmonte Toledo

Dpto. de Mecánica Aplicada e Ing. de Proyectos

Universidad de Castilla-La Mancha

Juanf.belmonte@uclm.es

---------------------------------------------------------------------------------

Escuela de Ingenieros Industriales

Campus Universitario s/n, 02071, Albacete

Tfno: 967599200-ext:2399

---------------------------------------------------------------------------------

Instituto de Investigación en Energías Renovables

Sección de Eficiencia Energética y Sistemas Térmicos (ENERSYS)

C/ de la Investigación, s/n, 02071, Albacete

Tfno: 967599200-ext:8217

---------------------------------------------------------------------------------