Dear David,
Thank you very much for your answer.
I already found almost the same answer from several years ago and
thus did everything you recommended (despite contacting my
distributor) without any success.
I was hoping that it is something like an easy-to-fix known
compatibility issue, but it seems to be more difficult.
Best,
Philip
On 5/20/2014 6:39 PM, David BRADLEY
wrote:
Philip,
A range check error is a very generic Fortran message for an
error that wasn't cleanly caught in the code. For example if the
argument to a LOG() function is not checked to make sure that it
is positive then you might get a range check error when Fortran
tries to execute the LOG() function. The first thing to try is to
switch TRNSYS into it's "debug" mode. The switch can be found in
the Simulation Studio control cards (where you set the start and
stop time). This does some extra error checking and might give you
a bit more of a hint about what is going on. However, you will
probably need to send your question in to your distributor's
hotline for assistance in debugging.
Best,
david
On 5/20/2014 08:40, Philip wrote:
Dear All,
once I open and then save a validated and well working building
model created on another PC I can not run the simulation
anymore:
I receive a "Range check error"!
The building was created with the same TRNSYS version
(17.01.0028) that I am using, the only difference is that I have
a 32bit system and the building was created on a 64bit machine.
Is this a known issue?
Is there a solution so that I can modify the building myself?
Thanks a lot for your efforts!!!
Best,
Philip
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com
|