[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] IF statemenet

Hi
There is not any "IF" statement in equation.However you can use greater than (GT) or less than (LT) in equation box to make your conditional statement.
Regards,
Soudabeh


On Fri, Feb 14, 2014 at 12:19 AM, metkell yebiyo <metkell@yahoo.com> wrote:
Dear TRNSYS users,

Could you anyone tell me if it is possible to write an if statement in the equation box,
I am trying to send a control signal based on the outside temperature, if outside air temperature is
greater than 18 deg C then the heat pump would run in cooling mode else if the outside air temperature is less than 14 deg C then  the heat pump would run in heating mode.

Any suggestions would be appreciated thank you very much.


Regards,
Metkel

Metkel Yebiyo BEng (Hons), MSc
CEREB PhD Researcher - Ground Source Heat Pumps
Room T615
Department of Urban Engineering
Faculty of Engineering, Science and the Built Environment
London South Bank University,
103 Borough Road,
London SE1 0AA
Tel: +44 (0)20 7815 7639
E: yebiyom@lsbu.ac.uk

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users