Dear TRNSYS users,
Could you anyone tell me if it is possible to write an if statement in the equation box,
I am trying to send a control signal based on the outside temperature, if outside air temperature is
greater than 18 deg C then the heat pump would run in cooling mode else if the outside air temperature is less than 14 deg C then the heat pump would run in heating mode.
Any suggestions would be
appreciated thank you very much.
Regards,
Metkel
Metkel Yebiyo BEng (Hons), MSc
CEREB PhD Researcher - Ground Source Heat Pumps
Room T615
Department of Urban Engineering
Faculty of Engineering, Science and the Built Environment
London South Bank University,
103 Borough Road,
London SE1 0AA
Tel: +44 (0)20 7815
7639