Dear all
I'm simulating an autonomous photovoltaic system and I have doubts about some parameters of elements
- Type94
Input 3: Load voltaje. I do not know what value is right, I'm working with 24V (voltage of the designed system) do not know if it will be 0 (default), or 45V (datasheet of panel: Current-Voltage & Power-Voltage Curve).
-Type48d
Input 4: Battery voltage (BV). I put 24V which is the system voltage. But so I have connected it to the total current of battery type 47b. Can I leave this setting?, Or should I put INPUT4 in 0 (default) and connected to the battery?, Or as I connect?
Input 5: Max battery input. I connected it to max. power of charge of battery. But the input 5 I left with a value of 0. I must leave the 0? Or change to battery power?.
Input 6: Min. battery output. I plugged of max. power of discharge of battery. But I left the input 6 with value 0. I must leave the 0? Or change to battery power?.
Input 7: lower limit on battery voltaje. I plugged of discharge cutoff voltaje (DCV), but I'm not sure if this is the proper connection.
Input 8: Power corresponding to BV. I do not know what is the “Power corresponding to lower limit on battery voltage during discharge”, I connected of power corresponding to DCV of the battery.
Input 9: High limit on BV. I do not know what is the “Higher limit on battery voltage during charge”, I plugged of carge cut off voltaje to CCV of battery, but I'm not sure.
Than you everyone
Deputy the simulated system
Attachment:
SolarPV.rar
Description: application/rar