[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Combined paralle and series collector array with different orientation

You'll need to drag out two collectors.  The first should have an area of 10x the single panel area and have the number in series set to 1.  Connect the output from this collector to another collector where the area is set to 4x the single panel area and the number in series set to 2.

 

Jeff

 

---

Jeff Thornton

President - TESS LLC

22 N. Carroll Street, Madison WI USA 53703

Office: (608) 274-2577  Fax: (608) 278-1475

www.tess-inc.com

E-Mail: thornton@tess-inc.com

 

On 08/10/2013 2:01 pm, Igor Seso wrote:

Dear Jeff,

In the attachment I provide a simple connection scheme of the collector array, hope that is will clarify.

Regards
Igor
From: Jeff Thornton
To: trnsys-users@cae.wisc.edu
Sent: Tuesday, August 6, 2013 8:55 PM
Subject: Re: [TRNSYS-users] Combined paralle and series collector array with different orientation

parallel connected  (each 2m2, south-west orientated, tilted 30 degrees)  and then they're serial connected to another 2 collectors(each 2,5 m2 which are parallel connected between them, south orientated, tilted 40 degrees). Again this array is in parallel connected with exactly  the same  array of collectors. Can someone give me directions hot to define the solar collector array in the simulation?>
 
I followed your e-mail until the line: "Again this array is in parallel connected with exactly  the same  array of collectors"  Can you provide a simple sketch of the collector array so we can help you set the collector parameters?
 
Jeff
 
---
Jeff Thornton
President - TESS LLC
22 N. Carroll Street, Madison WI USA 53703
Office: (608) 274-2577  Fax: (608) 278-1475
E-Mail: thornton@tess-inc.com
 
On 08/05/2013 12:58 pm, Igor Seso wrote:
Dear TRNSYS users,
I'm new with TRNSYS, so I want to simulate system for heating DHW in a hotel using solar thermal collectors(flat plate). 
The difficult is that there are 5 collectors parallel connected  (each 2m2, south-west orientated, tilted 30 degrees)  and then they're serial connected to another 2 collectors(each 2,5 m2 which are parallel connected between them, south orientated, tilted 40 degrees). Again this array is in parallel connected with exactly  the same  array of collectors.
Can someone give me directions hot to define the solar collector array in the simulation?
Thank you in advance
Igor  

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users