<I'm new with TRNSYS, so I want to simulate system for heating DHW in a hotel using solar thermal collectors(flat plate). The difficult is that there are 5 collectors parallel connected (each 2m2, south-west orientated, tilted 30 degrees) and then they're serial connected to another 2 collectors(each 2,5 m2 which are parallel connected between them, south orientated, tilted 40 degrees). Again this array is in parallel connected with exactly the same array of collectors. Can someone give me directions hot to define the solar collector array in the simulation?>
I followed your e-mail until the line: "Again this array is in parallel connected with exactly the same array of collectors" Can you provide a simple sketch of the collector array so we can help you set the collector parameters?
Jeff
---
Jeff Thornton
President - TESS LLC
22 N. Carroll Street, Madison WI USA 53703
Office: (608) 274-2577 Fax: (608) 278-1475
E-Mail: thornton@tess-inc.com
On 08/05/2013 12:58 pm, Igor Seso wrote:
Dear TRNSYS users,
I'm new with TRNSYS, so I want to simulate system for heating DHW in a hotel using solar thermal collectors(flat plate).
The difficult is that there are 5 collectors parallel connected (each 2m2, south-west orientated, tilted 30 degrees) and then they're serial connected to another 2 collectors(each 2,5 m2 which are parallel connected between them, south orientated, tilted 40 degrees). Again this array is in parallel connected with exactly the same array of collectors.
Can someone give me directions hot to define the solar collector array in the simulation?
Thank you in advance
Igor
