[TRNSYS-users] error when importing trnsys 3d- model in simulation studio

[Jorn Ostijn <jorn.o@vkgroup.be>]

Hey everyone,

When making a 3D Building project (multizone), I encountered an error when trying to open my .idf-model (google sketchup).
The error is the following:
"At least 2 surfaces are required per zone!"

What 's weird about this error, is that I can not find a zone consisting of less than 2 surfaces + I can't find "surface -1" in my model.

I searched but have not been able to solve this error yet.
Is anyone familiar with this error? Where lies the problem?
You can find my .idf-model in annexe.

Thank you very much for helping me out,

Jorn Ostijn

Project engineer
VK Engineering

 

 SUBSCRIBE TO OUR E-LETTERS     click here 

****DISCLAIMER****
This communication is confidential and for the sole useof the addressee. If you are not the intended recipient,
please immediately notify the sender by e-mail at the address shown and then delete it from your system
without copying, disclosing or forwarding its contents. Thank you.

 

 

Attachment: 31854_simPHPP_20130320_model_Verbeke25_b17.idf
Description: 31854_simPHPP_20130320_model_Verbeke25_b17.idf