[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TRNSYS-users] range check error
Raffaele -
A range check error is a generic FORTRAN error and can be hard to
diagnose. But I suspect that your error is caused by trying to set an
exterior surface to have an internally calculated convective
coefficient. Exterior surface convection coefficients must be user
defined or inputs.
Regards,
Tim
---
Timothy P. McDowell
Executive Vice President
Thermal Energy System Specialists, LLC
22 N Carroll St, Suite 370
Madison, WI 53703
608-274-2577
On 2013-03-18 06:09, raffaelecazzato@libero.it wrote:
Good morning,
when I select in the wall type, internal calculation for the
convective
coefficient,
the simulation will start only if I select one of two options front
or back,
if I select both, the simulation does not start and exit the
following error
message:
range check error.
I would know someone help.
Reagards,
Raffaele
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users