Hi,
I’m a student of mechanical engineer in Rome, I’m using Trnsys studio 16 to
simulate what happens to the internal temperature of a urban bus during the hot
summer when there is the opening and closing of the doors at the stops. I have
created a schedule in which every 5 minutes there is a change of air for 1
minute from the 3 doors of the bus. The problem is that for every different type
of schedule (a stop every 6,7,8,10 minutes) the program doesn’t run over one
hour... I need to see what happens from 12 pm to 15 pm (the most hot hour of the
day) but the program run only from 12 to 13 pm and then stops saying “range
check error”... the only setup tha works good in 3 hours is setting a stop of
one minute every 20 minute... but it is not realisti 20 minutes... So I need the
way to make work good the program with a stop of one minute every 5 minutes for
3 hours.
I hope to have been clear in telling about this problem...If you can help
me it would be great! thanks for the attention!
Best regards,
Emanuele Santovito |