[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Problem with Type 501



Samir -

Type 501 is a ground temperature profile model and not a ground heat exchanger model.  You will need to switch to an actual ground heat exchanger model.

In the future please only post your question once to the message board. There is no need to repeat the same question over and over.

Regards,

Tim

---
Timothy P. McDowell
Executive Vice President
Thermal Energy System Specialists, LLC
22 N Carroll St, Suite 370
Madison, WI 53703
608-274-2577

On 2012-06-06 07:59, Samir CHEHAL wrote:

Dear Users,

I must modelize a geothermique pump and I must study the temperature rise at 300m depth.

I connect type 501 with a heat exchanger and I connect this heat exchanger with my heat pump.

The problem is that there are not inputs in type 501 to connect with Hot/Cold side temperature of heat exchanger.

And so I don't know how obtain the rise of temperature in the ground (at 300m depth).

Best regards