[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Calling Matlab

Hello Everyone,

I am trying to  run  a component  written  in MATLAB  in TRNSYS.  For that, I added  Type 155 calling MATLAB to my project and run my TRNSYS tpf file. It runs smoothly and gives some out put. In the corresponding m-file ( given under special cards), I inserted my m-file code in the space for 'all iterative calls' and saved the file. When I run the file, it shows an error "The M-file did not properly set ‘mFileErrorCode’ to 0 when it was called".

Can any one explain this? How can I set set ‘mFileErrorCode’ to 0.
Your reply highly appreciated.

Regards
Ramadas