Re: [TRNSYS-users] Genopt and type 56

[David BRADLEY <d.bradley@tess-inc.com>]

Louis,
  That message is coming from TRNBuild and is typically generated if GenOpt tries to open a *.bui file that doesn't exist. I'm not sure how your configuration is set up but bear in mind that in some configurations, GenOpt is running a copy of your input file that is at a different location than the original location. If you have specified any relative paths in your input file, they will probably not be valid from the location of the input file copy. Try to specify all of your paths as absolute (starting with the drive letter)
Best,
 David


On 1/12/2012 05:19, STEPHAN Louis 231500 wrote:

Dear All,

 

I am trying to use Genopt with a problem using Type56. I followed all the steps and when Genopt try to lunch a TRNSYS simulation I get the following error message from TRNBuild: no OUTPUT’s specified, please add at least on OUTPUT. I really don’t understand the problem. Can anyone please help me with this? I am using TRNSYS V17 with TRNOPT17 and Genopt 3

 

 

Thank you very much,

 

Louis Stephan

Ingénieur Chercheur / Docteur

----------------------------------------------------------------------------

Laboratoire d'Energétique du Bâtiment (LEB)

INES / CEA

Recherche, Développement, Innovation Industrielle

50, avenue du Lac Leman

73377 LE BOURGET DU LAC, France

Tel: +33 (4) 79 60 19 42

 

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com