[TRNSYS-users] PVT (type560) in Series Connection

[Cheong Chu Siang Jesper <u0706752@nus.edu.sg>]

Hello!

I'm modelling a 52-module PVT cluster for co-generation of hotwater/electricity and the configuration of the modules are in a 13x4 arrangement (13 parallel lines with 4 collectors each in series). Single tank.
Type 560 is used for all 52 modules while single tank is represented by type 534.
However, tank temperatures were found to be at least 5 deg lower than expected.
Also, significant flowrate variations did not change collector outlet temperatures much.
This seems to suggest that the 560 models do not factor in the effect of series connections, and to test this i set up a basic system consisting of 2 560s in series, pump(w/ differential control) and single type534.
Outlet temps frm both 560s were taken and they were the same. 

Some qns:
1. Did i miss out anything when dealing with the abovementioned models?
2. Or is this a limitation of the 560 models?
3. If this is a limitation, are there any other PVT models available that can fulfil my requirements?

Help is greatly appreciated!
Jesper
National University of Singapore

________________________________________
From: trnsys-users-bounces@cae.wisc.edu [trnsys-users-bounces@cae.wisc.edu] On Behalf Of trnsys-users-request@cae.wisc.edu [trnsys-users-request@cae.wisc.edu]
Sent: Friday, September 30, 2011 23:58
To: trnsys-users@cae.wisc.edu
Subject: TRNSYS-users Digest, Vol 81, Issue 62

Send TRNSYS-users mailing list submissions to
        trnsys-users@cae.wisc.edu

To subscribe or unsubscribe via the World Wide Web, visit
        https://mailman.cae.wisc.edu/listinfo/trnsys-users
or, via email, send a message with subject or body 'help' to
        trnsys-users-request@cae.wisc.edu

You can reach the person managing the list at
        trnsys-users-owner@cae.wisc.edu

When replying, please edit your Subject line so it is more specific
than "Re: Contents of TRNSYS-users digest..."