Hello, I am simulating 30 years of hourly data with TRNSYS. Around hour 450000, I get the error ‘Range check error’. When I switch on the debug mode, I get the error
‘An OUTPUT from the specified component model has been written to the global OUT array in a location beyond the allocated number of outputs from this model. Please
check the component carefully to insure that INFO(6) is set correctly. The simulation has been aborted to avoid problems caused by over-writing the outputs from other component models’. The model where this error refers to, has the correct nr of outputs specified
in the code… However, this error isn’t there when I switch the debugger off. What can I do to fix these errors? With kind regards Kundert de Wit
Get
connected via LinkedIn |
Volg ons op Twitter |