|
Dear TRNSYS-users, I am simulating a room with an active layer in the separating wall. I tried to change the simulation timestep to 1 min. to get more exact results. What I realized is, that the output started to show discrete results in an hour interval. My Question: Could it be that TRNSYS has a limitation in the active layer system, to solve it in one hour timesteps only? Can I change this somehow? Thanks for your help, Florian FLORIAN STIFT, DI(FH) Energy Department Sustainable Building Technologies AIT Austrian Institute of Technology Österreichisches Forschungs- und Prüfzentrum Arsenal Ges.m.b.H. Giefinggasse 2 | 1210 Vienna | Austria T +43(0) 50550-6277 | M +43(0) 664 815 79 46 | F +43(0) 50550-6613 florian.stift@ait.ac.at | http://www.ait.ac.at FN: 165088b HG Wien | UID: ATU46577208 This email and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient, please notify the sender by return e-mail or by telephone and delete this message from your system and any printout thereof. Any unauthorized use, reproduction, or dissemination of this message is strictly prohibited. Please note that e-mails are susceptible to change. Österreichisches Forschungs- und Prüfzentrum Arsenal Ges.m.b.H. shall not be liable for the improper or incomplete transmission of the information contained in this communication, nor shall it be liable for any delay in its receipt. |