Davide,
You just need to switch from defining a "massive layer" to a
"massless layer"
Regards,
David
On 2/8/2011 18:23, davide disco wrote:
Hello,
when I add a wall I have to
specify the layers that
make up the
wall, and for each new layer Trnsys
requires three quantities: conductivity, capacity and density.
Now, the capacity is expressed in KJ/(Kg K), but for the
layers of wall I have the thermal conductivity
(expressed in W/m²·K) instead of the capacity as
required by
the program.
There is a way to correlate this two quantities so that I can
enter the thermal conductivity instead of the capacity?
Thanks in advance
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com
|