Thank you, I was using ***.idf file in spite of ***_b17.idf It works well now. Best regards. Le 28/10/2010 09:17, hotline a écrit : Hi Rémy, this sounds like it doesn't find the link between data and surfaces. This can have two reasons: - the ***_b17.idf has to be used in order to visualize the results. There the surfaces have the same surfaceID's as in TRNBUILD - the initial value in the Trnsys3d Printer in the simulation Studio are not the same as the surfaceID's in TRNBUILD or the ***_b17.idf. These initial values are used to generate the link to the surface numbers in the 3D geometry. Christian TRANSSOLAR Software Team hotline@transsolar.com www.trnsys.de Transsolar KlimaEngineering - Technologien für energieeffizientes Bauen und Nutzerkomfort in Gebäuden Transsolar Energietechnik GmbH, Curiestrasse 2, 70563 Stuttgart / Amtsgericht Stuttgart - HRB 23347 / USt-IdNr.: 99073/00911 Geschäftsführer: Dipl.Ing. Matthias Schuler, Dipl.Ing. Thomas Auer, Dipl.Phys. Stefan Holst, Prof. Volkmar Bleicher -----Ursprüngliche Nachricht----- Von: Rémy Saulnier [mailto:remy_saulnier@holisud.fr] Gesendet: Mittwoch, 27. Oktober 2010 15:19 An: trnsys-users@cae.wisc.edu Betreff: [TRNSYS-users] Exporting surface data on Trnsys3d _______________________________________________ TRNSYS-users mailing list TRNSYS-users@cae.wisc.edu https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users |