[TRNSYS-users] Results for QSEN (NTYPES 2) do not appear after the simulation.

[GANAPATHY.IYER@Thermaxindia.com]

Hi all,
I am trying to calculate the sensible
and latent heat load in a simple building. But whenever I enable the outputs
NTYPE2 i.e. QSEN for any airnodes, the result is always 0. 
I used the Sun-Space example where I
enabled the output for QSEN, but when I print the results, it always shows
this value to be 0. 

Has anyone used this successfully? 
Some examples will be helpful

Regards
Ganapathy Iyer
THERMAX PUNE

 ================================================================================================================
DISCLAIMER :
The information in this email is confidential and may be legally
privileged.It is intended solely for the addressee. Access to this email by anyone else is unauthorized.If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. When addressed to our clients any opinions or advice contained in this email are subject to the terms and conditions.