Hello,
I'm trying to use trnsys3D, which seems
very promising.
I have two very simple questions.
1)
Is it possible to define two walls in the
same plane, as shown on the following figure ?
It's a door inside a wall.
According to my experience, this is not
possible because TRNSYS3D will define two walls :
-
the door (0.9*2.01),
-
the full wall (3*3.44), and not
(3*3.44) - (0.9*2.01)
Could you please correct me if I'm wrong/confirm
what I think/give me any trick that I would have missed? (Probably the only
option is the following :
2)
The manual seems to say that it is possible
to directly import .idf file in TRNbuild…
But this option is not available in my
version of TRNbuidl (2.0) :
Is this normal ?
Thanks,
Kind regards,
Nicolas Heijmans
Belgian Building Research Institute (www.bbri.be)
Av. P. Holoffe 21, B-1342 Limelette, Belgium
tel. : + 32 2 655 77 87 fax : + 32 2 653 07 29